Outdoor cabinet suggests that it is often used in outdoor, often in harsh environments, so in order to ensure their internal equipment from its weather, outdoor cabinets typically have the following 10-point technical requirements:
        1, for linear dimension tolerances according to GB1804-M-class processing.
        2, did not note the interior angle of bending R0.5. Welding polished outer R angle is not playing in R6, all the plate thickness shall comply with the national standard.
        3, the cabinet and the front door diagonal tolerances are ± 5mm, cabinets, doors, roof, base made of high-quality cold rolled steel, having a thickness of 1.5mm; steel parts as well as support the battery cell laminates to laminates quality cold rolled steel plate, the thickness of 2mm; door stop, door hinges, door flat bar made of stainless steel, thickness 2mm. (When the materials are changed otherwise stated)
        4, cabinet solid and reliable welding requirements, does not allow Weld, weld, weld cracks and other defects; each weld zone after spraying can achieve the same angular, beautiful, no uneven defect, the cabinet for outdoor cabinet, the surface should be sprayed outdoor organic coating, IP protection class IPxx 8, cabinet spray evenly, thickness 0.09mm-0.12mm.
        5. The surface of the cabinet does not allow paint, draw bumps, missed the end of the bubble, surface defects pinholes, cracks and other surface does not allow the cabinet rivet India spraying.
        6, the surface should be clean and should not have rust, dust, oil and other debris, waterproof tape brand of Qingdao virtues, tape does not allow damaged. Local contact strips and strips fight sealant.
        7, ban the front door with a good, guaranteed access control function is normal, no off angle phenomenon front door, the front door switch process does not allow the cabinet and the hinge interfere scrape paint so that the phenomenon of friction.
        8, cabinet front inlet cover four weeks to fight gum, door core switch process can not scrape the cabinet, not water at the blinds, while the inside of 1mm stainless steel welded mesh filter, cabinet tops hinges and card seat buckle rivet nut use BS-M6, all gluing are not allowed at the colloidal impurities and other dirt, gluing tidy.
        9, waterproof connector with a black rubber sealing sheet is necessary, and firmly installed below the front hub leaking hole, base plates and a front panel to be able to disassemble put it, there can be difficulty installing or removing other phenomena, grounding wire with 4mm2 yellow-green wire .
        10, all parts and fasteners riveted requirements of stainless steel, Rivet pieces of aluminum (except rings), positive displacement and ground row with hex bolts and washers (GB5781, GB93, GB97), by location complete with panel screws and captive nuts, locking all necessary mounting screws, necessary protection riveted thread spraying; do not allow loose, slippery bud, bud rot, screw skew, the screw head hit the burr (screw head smashed) and other phenomena, cell layer net space: wide deep , generally in accordance with the specific requirements of customers, the turret no off angle phenomenon. (Air-cooled cabinet), power-supply cage protection class IPXX; battery compartment protection class IPXX.
         Finally, to ensure the cabinet can work in normal outdoor environment, play a normal protective role, therefore, have to do the best waterproof cabinet, so the cabinet put into production use, the cabinet manufacturers need to do water testing, to to ensure that the cabinet during use, water level can be achieved in the future.